Before proceeding with standardization of the Fisher Sub Sieve Sizer,the following items shall be checked:The chart shall be properly aligned horizontally with the indicator pointer.
HMK-22 Fisher Sub Sieve Sizer / Average Particle Size Analyzer by Aimsizer Scientific
The method is applicable only to powders which flow freely through the specified test orifice.
AS-300 Hall Flowmeter by Aimsizer Scientific
Carry out the determinations on three test portions.
AS-200 Scott Volumeter by AimSizer Scientific
The bulking properties of a powder are dependent upon the preparation,treatment,and storage of the sample,i.e.how it was handled.The slightest disturbance of the powder bed may result in a changed bulk density.
AS-100 Tap Density Tester
The balance has a capacity of at least 50 g and a sensitivity of 0.001 g.
Fisher Sub Sieve Sizer
HMK-22 Fisher Sub Sieve Sizer / Average Particle Size Analyzer by Aimsizer Scientific
This international Standard specifies a method for determining the flow rate of metallic powders, including powders for hardmetals,by means of a calibrated funnel (Hall Flowmeter).
Hall Flow Meter/Flowmeter Funnel
AS-300 Hall Flowmeter by Aimsizer Scientific
Determine the mass of the powder to the nearest 0.05 g.
AS-200 Scott Volumeter by AimSizer Scientific
The bulk density is expressed in grams per mL although the international unit is kilograms per cubic meter because the measurements are made using cylinders.It may also be expressed in grams per cubic centimeter.
as-100 tap density tester
Adjust the sample packing assembly (1) as described in the manufacturer’s directions with the exception that the plugs and paper disks are not inserted in the sample tube,but are merely stacked together and placed between the brass support and the “flat” of he bottom of the rack,and (2) as previously described except that a specially made baseline gauge is used instead of the plugs and paper disks.This baseline gauge shall have a height of 19.3+-0.1mm.Check all plug heights when new plugs are purchased and periodically thereafter to make sure all are equal in height.
HMK-22 Fisher Sub Sieve Sizer / Average Particle Size Analyzer by Aimsizer Scientific
No statement can be made about bias,because there is no standard reference material for flow rate measurement.
AS-300 Hall Flowmeter by Aimsizer Scientific